2021-2024 RAM 1500 TRX Stealth Fighter Front Bumper
F620153030103
PRODUCT DESCRIPTION
The Stealth Fighter Front Bumper is a low-profile plate steel design. The radiused front end keeps it tight to the front of your Ram TRX while following key bodylines to make it look like it belongs from the factory. A universal light mount system allows for a 40" curved light bar or up to cube lights in the center of the bumper, and there are two additional cube light mounts behind each side panel.
A full skid plate comes down and attaches in factory mounting locations to make sure your shock reservoirs remain protected. Installing the Stealth Fighter improves your approach angle by 4-inches. OEM amenities such as parking sensors and marker lights are retained. Reinforced clevis mounts provide a mounting point for soft shackles. As always, this product is fully bolt-on and made in America.
Features
- Radius plate steel design
- Universal light mount for 40" curved light bar or up to 10 cube lights
- One cube light mount behind each side panel
- Retains OEM marker lights
- Works with both sensor and non-sensor models
- Reinforced Clevis Mounts Accept Soft Shackles
- Made in America
Model
Trim
2021-2024 RAM 1500
TRX
WARNING: This product can expose you to chemicals including silica, crystalline, which is known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov.
- Steel Plate Design
- Center Lights
- Side Lights
- OEM Functionality
- Fit & Finish
Steel Plate Design
A radius plate steel design ensures the Stealth Fighter can sit as close to flush as possible to the truck for a clean look while allowing the use of a curved light bar.
Center Lights
Our universal light mount system allows the use of any brand 40-inch light bar in the center of the bumper. Alternatively, there are mounting solutions for up to 10 cube lights in that section.
Side Lights
You can mount a cube light behind each side panel of the bumper.
OEM Functionality
The bumper was designed to retain the OEM marker lights and parking sensors in equipped models.
Fit & Finish
We design our bumpers to have the best fit & finish on the market, ensuring our bumpers not only look great, but are made to last. After sandblasting, we apply a hammer black powder coat finish across the entire bumper.
More Images
Our Mission
It’s ADD’s mission to design and build the best off-road parts to fit seamlessly with the lines of your truck or Jeep and perform at the highest level. Our parts are engineered to hold up against the elements and off-road driving. From design to the finished product, we create our bumpers and accessories out of our facility in Chandler, Arizona.
We keep our ear to the street when developing new products and utilize the feedback we receive from the off-road community. We work hard to be sure we’re proud of the products we send out for you to enjoy.